6.5 Creedmoor Lapua Brass & Hornady Custom Grade Die Question

B

bubba300

CGN Regular
Rating - 100%
45   0   0
Hey I have the small primer brass and hornady dies,my decapping pin is tight in the flash hole,hornady lists .060 small and Mine is .070,just wondering if anyone has tried the small pin and how it worked in the lapua brass.It does deprime but just a little stiff.
Thanks
 
Hum, the small primer flash hole is .059-.060" usually, so if you're depriming with a .070" pin now, I could see a problem...
Get/make smaller pins, make sure they fit by hand in the flash hole with a few thou of play.
I made my own decapping die & pin, pretty sure its .055" at the tip, works for everything.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom