freddyfour
CGN Ultra frequent flyer
- Location
- Brant County, Ontario
You've been on a 30-30 bender last few weeks eh. Nice find should be a nice deer getter.
They were aftermarket, but obviously because of the popularity the rifles were factory pre-drilled for them. Probably both - yours and mine are 50's era correct sights.
Thanks Guys. Barrel was full of dust and some spider webs and you can see a small surface rust at the muzzle. I used a bore snake and oil and it's all shiny now.
May take it to gunsmith for complete disassembly, but I feel lucky![]()
No need to take it apart, I wouldn't think. All that will do is bugger up perfect screwheads and maybe scratch the finish here and there. The gun will work fine. Unless a 94 has worn or broken parts I don't ever advise disassembly. They can be cleaned and lubricated easily with aerosols. I would drift the rear sight out and put a 3/8 blank in the dovetail or if you like the buckhorn sight remove the peep.
and I can't put the rear sight any lower. JUst an FYI.Good info, thanks. Didn't know it was factory drilled.
You probably found an old corvette in a barn once too. Lucky bastard!




























