7.62x39 AR build

id64

CGN frequent flyer
Rating - 99%
99   1   0
Location
Toronto, Ontario
SigSauer lower with Geissele (G2S) Trigger

DD upper with NEA 14.5 barrel, bolt and firing pin. Surefire 7.62 brake

Troy hand guard and backup sights, Aimpoint H1, Magpul UBR stock and pistol grip and AFG2
XCR 10 rounders.

DSC_1159-small.jpg
 
Not a single problem with G2S. This bolt came with custom firing pin that protrudes farther that a regular 556 pin would and it's fatter.



No problems with light primer strikes out of the G2S?? I had to swap mine out for a standard trigger with heavy hammer spring to make it 100%.
 
So far I've got the best results with Russian surplus ammo, about 1MOA and less at 100m. PMC works pretty good as well. Romanian and czech ammo is so-so. Gas block is the regular 5.56 low profile with carbine length tube.

Looks good!
How's the accuracy with that NEA barrel? What size gas block and is it mid-length?
 
No problems with light primer strikes out of the G2S?? I had to swap mine out for a standard trigger with heavy hammer spring to make it 100%.

Geissele uses full weight Springs on all their triggers. However they do use a lighter hammer. That probably was cause of light strikes, rather than spring weight.
 
I was quite surprised myself. Haven't had a chance to reproduce this result at 100. Might take it to the outdoor range soon to confirm

1 MOA or less @ 100 meters! I'm impressed.
I cannot even get a bolt action to shoot surplus that good.

I'm convinced that the carbine length gas port and 7.62x39 is the most reliable setup.
 
Back
Top Bottom