.735 roundballs supply?

hansol

hansol

Regular
Rating - 100%
26   0   0
Location
AB
Hey there,

I think this is the best forum to ask this question: I'm just wondering if anyone here has any experience casting .735 roundballs, or knows of some place in Canada where I can order HARDCAST .735 roundballs?

Right now I'm too poor to buy a whole bullet-casting setup, so was hoping I could either find a place that sells the hardcast in .735, or if any CGN members have the molds and want to work something out.

Thanks very much guys -Cameron
 
I make and sell all matter of round balls, however not .735 due to that size causing possible problems in .693" full choke barrels, especially as the alloy made be hard if asked for....so I make .715 as a good comprimize.
 
I use them for a roundball load in a 12 guage. 12 guage = .729cal, so I need something just a little bit bigger the swage properly.
 
Ok I use them with patches in my 10. I looked and it is a .735" mold. I might be able to make you some up, but I may not be casting for a while. Are you in a big hurry for them, I occasionally make it to Calgary and could deliver, saving you shipping costs.

You can PM me anyway if you don't find a better source.
 
You must log in or register to reply here.
Back
Top Bottom