7mm rem mag and h4831sc

[Rosie1234]

Just trying to find data for 7mm rem mag, h4831sc and 140gr accubond or partition. Only info I have found is on Hodgon's web site. I will go by there numbers but the velocities seem low. Thanks for any info

 

[dan belisle]

Just trying to find data for 7mm rem mag, h4831sc and 140gr accubond or partition. Only info I have found is on Hodgon's web site. I will go by there numbers but the velocities seem low. Thanks for any info

Try Noslers website. - dan

 

[45C]

I went with the IMR 4831 data, just started off low.
I might still have the data somewhere,I’ll check later today

 

[jerrya]

https://www.nosler.com/7mm-remington-magnum

 

[Butcherbill]

If I understand correctly H4831 & H4831sc are the same powder with the exception of the sc being cut into shorter pieces for better metering?

 

[dan belisle]

If I understand correctly H4831 & H4831sc are the same powder with the exception of the sc being cut into shorter pieces for better metering?

That's the idea, yes. - dan

 

[mikeyb]

If I understand correctly H4831 & H4831sc are the same powder with the exception of the sc being cut into shorter pieces for better metering?

I've been using the data interchangeably and it works fine for me (I have a few pounds of repackaged H4831 from Higginsons that I've used SC data with no problem). I think if there was a material difference they'd err on the side of caution and just give it a different name altogether.

 

[waldo54]

H4831sc behind a 175gr ELDX in my 7PRC is and awesome load, shoots well under 1/2" at 100 yards and good velocity