9x19 Powder What are YOU using?

used to use Titegroup but the margin of error on this load is so small that I switched to Unique.
4.8-5.0gr under 124jacketed or 125gr lead bullet.
 
HS6..this is the power I use for all my 9mm load including 9 major. At one time I used a 9X21 and HS6 was the only power to make it to major without showing excessive pressure. My friend load all is 9 with Titegroup and he got good accuracy from different 9 mm guns with it.
 
5.3gr unique under a 124gr bullet.

I find it to be dirty compared to red dot and w231 though.

I use it because I use it in other cartridges as well and it simplifies storage.
 
Ramshot Silhouette. It gets good reviews on Brian Enos. I use it to load both 9mm Major (for IPSC) and 9mm Minor. It burns very clean. It is easily attainable.
 
Bullseye here too. Not too satisfied so far in my SR9 cos of occasional keyholing. That was with 4.4gr BE. Some leading too. Sized 358.

Made a whole bunch of 4gr, but no time to test it lately. I use BE cause I also use it very successfully for reduced loads in my 30-30. 7grs gives me really good accuracy there.
 
5.0 gr of unique / 124's ..not real pleased with the accuracy tho. I had a couple of boxes of factory refurbished..AE/124 gr lead RN's...they were the best, most accurate load ever in my Baretta 92/9mm !!!! .....Buttttttt.....I just got some clays and longshot to try out, soooo....hopefully I'll find a load the same as the AE factory stuff.
 
I bought some SR 4756 to load some, but it seems very dirty. I may have to switch to something diffrent once I run out of it
 
You must log in or register to reply here.
Back
Top Bottom