A quick question for you precision guys.

T

TrxR

CGN Ultra frequent flyer
Rating - 100%
20   0   0
Location
Sussex, NB
I was wondering if you guys could give me an idea on how tall your long range bolt rifles are from the lowest part of the stock to the highest part of the scope? I know this is dependent on the scope and stock but was hoping you could give me an idea. Also if you were going to build a box to hold two rifles standing up , not on its side what width would you recommend? Would 8 inches inside be enough for two rifle to sit comfortably side by side without damage.

Thanks
 
Guessing mine is around 10 inches high, 3 inches wide, so 25cm x 7.5cm? in head conversion.
With two or 3 cushioned pillars to divide I think you could get away with 8 inches wide.

If you are building safe storage 8 would be fine. To transport Precision I'd add an
inch or two for padding.

I can measure exacts if you wish this weekend on my factory F/TR if you are designing.
 
MarkHFX said:
Guessing mine is around 10 inches high, 3 inches wide, so 25cm x 7.5cm? in head conversion.
With two or 3 cushioned pillars to divide I think you could get away with 8 inches wide.

If you are building safe storage 8 would be fine. To transport Precision I'd add an
inch or two for padding.

I can measure exacts if you wish this weekend on my factory F/TR if you are designing.
Click to expand...
That's pretty darn close to my measurements. 44.5 inches long, 3.5 wide and 9.5 inches high.
NF 12-46x56mm scope on a factory Remington 700 Varmint.
 
You must log in or register to reply here.
Back
Top Bottom