Adjusting Ghost holster??

kb007

kb007

CGN frequent flyer
Rating - 100%
4   0   0
Location
Rural Ottawa
I just got a Ghost The One holster for my CZ75 SP01 Shadow. The trigger guard pops in nice and easy, but it takes both hands to pull it out, which just ain't right. Regardless of how I try to pull it out - up and out or any other way, it's just way too hard to pull out.

I have it adjusted for length so the trigger guard is locking in the right place, and no I'm not leaving the lever in the wrong position.

If I remove the locking lever, there is a spring - do I need to cut that spring? It seems that I can turn the brass piece (loosening the set screw) but it looks like I'd need to take it out a full turn to still have the retainer piece line up.

What have you guys done to adjust these?
 
You need to adjust the muzzle peg. I think you will find that it is currently either too far out or too far in on the bracket. This misalignment will put a lot of torque on the gun when it's rolled into the trigger lock, making it much harder to draw. The gun should just drop into place on the peg.
 
Ok, thanks, will give that a try. Right now it's set so that there is maybe less than 1/16 pf an inch between the bottom of the frame and the holster.
 
relliorr - thanks. Seemed that moving the peg out a little as well as turning the brass ring a little rearward seems to have fixed it.
 
You must log in or register to reply here.
Back
Top Bottom