Advice Regarding Tacticooling Tavor...

[int3grity]

I used med strength blue lock tight type stuff on the threads when I put on my barrel shroud. Is there a threat of damaging the rifle if i twist it off of the barrel because i noticed the barrel has flat parts in the front to use a wrench to secure it while putting on muzzle devices. That is covered by the barrel shroud. I think i will need to use a lot of force to untwist it from the barrel. Should I be worried?

The three prong flash hider I am leaning towards has an extended part that shrouds about half an inch of the end of the barrel and I think it would make the barrel look a little thicker. It is there to allow for a pin to go through a hole to tack it to the barrel with solder to legally extend barrel length in the USA.

 

[uklek]

Ditch the shroud. Follow what people have been saying and get the items you really need to fine-tune your Tavor. I'm currently running the Griffon Armaments M4SD-II Flashcomp, which essentially acts as both a compensator and flash hider rolling into one device.

There's quite a number of odds and ends you can add, just gotta have the cash to throw at it.

 

[DILLIGAF]

And the T97, that is a horrible trigger.

I cried when I first shot a T97... it was a mushy, long and it would never break in the same spot.

I also hate the factory Tavor trigger, This is why i have a Tav-D

 

[rommelrommel]

I used med strength blue lock tight type stuff on the threads when I put on my barrel shroud. Is there a threat of damaging the rifle if i twist it off of the barrel because i noticed the barrel has flat parts in the front to use a wrench to secure it while putting on muzzle devices. That is covered by the barrel shroud. I think i will need to use a lot of force to untwist it from the barrel. Should I be worried?

The three prong flash hider I am leaning towards has an extended part that shrouds about half an inch of the end of the barrel and I think it would make the barrel look a little thicker. It is there to allow for a pin to go through a hole to tack it to the barrel with solder to legally extend barrel length in the USA.

I'm not sure that loctite was a great idea but I don't think that blue is overly strong. Just use the jam nut next time.

 

[int3grity]

I'm not sure that loctite was a great idea but I don't think that blue is overly strong. Just use the jam nut next time.

The flash hider that I want to purchase has a lip that actually covers about half an inch of the end of the barrel so I will not be able to use a locknut with it.