Aimpoint Problem?

JNG

JNG

CGN Ultra frequent flyer
Rating - 0%
0   0   0
Location
Waterloo Region
I not familiar with Aimpoint Optics.
I got one recently and I think that there is a problem with it. When I look at a target that is in an area with less light than where I am a red hazy glare appears that occupies about 40% of the sight picture (on every power setting). If you draw a line from 11 o'clock to 5 o'clock and then move that line down just slightly so that it doesn't go through the dot that is the starting point of the red glare. From that line to the edge of the optic on the left has the red haze on any power setting. Just as an experiment I closed the front flip up cover and it was there plain as day on every power setting.
Needless to say it is very distracting...

Anyone else ever see this in an Aimpoint?
 
The Model is ML3. This is the non-night vision model but it apparently has the night vision electronics in it. A little mix up at the factory. I don't really care if it is nigth vision or not I just want to know how to get it to produce a dot without the red glare on the left side. It is definitely not on backwards either.
I was thinking that maybe the windage is set to the extreme right or left? I have mounted it but not shot with it so I don't know.
 
You must log in or register to reply here.
Back
Top Bottom