Anschutz Model 1365 in 9mm GATT - looking for a bolt and general info

[Tumbleweed450]

Hello CGN

I’m looking for info on the above rifle and on a longshot, I’m trying to find a bolt for one. This rifle is a family heirloom and at some point the bolt was lost. Any chances there could be one floating around? Is it possible to have a bolt made?

I’m out of my wheelhouse on this one so any assistance would be appreciated.

Thank you

 

[enefgee]

Western Gun Parts (?) or Numrich?

 

[Blastattack]

Other than completing it for the sake of completeness, there is little reason to bother. The ammunition is basically non-existent, as it’s a 9mm Rimfire Shotgun. Very limited utility. A new bolt could be made, but the cost would be substantial, and the system likely wouldn’t be strong enough to be adapted to a more readily available 9mm round.

 

[enefgee]

9mm Flobert is still out there.

 

[Tumbleweed450]

Other than completing it for the sake of completeness, there is little reason to bother. The ammunition is basically non-existent, as it’s a 9mm Rimfire Shotgun. Very limited utility. A new bolt could be made, but the cost would be substantial, and the system likely wouldn’t be strong enough to be adapted to a more readily available 9mm round.

Thank for the info and not surprising. Were any of these made with rifled barrels?

 

[Blastattack]

Thank for the info and not surprising. Were any of these made with rifled barrels?

I will admit I was somewhat harsh and wrong in judgement of the 9mm Rimfire round. It does exist still, and you can buy it. Intersurplus has stock, though not cheap by any means: https://intersurplus.com/collections/all/9mm-flobert

They do offer a round that fires a bullet, so a rifled bore is possible. Still though, I doubt you’ll find a replacement bolt for it for any reasonable price, and the cost of that ammo is substantial.

 

[Tumbleweed450]

I will admit I was somewhat harsh and wrong in judgement of the 9mm Rimfire round. It does exist still, and you can buy it. Intersurplus has stock, though not cheap by any means: https://intersurplus.com/collections/all/9mm-flobert

They do offer a round that fires a bullet, so a rifled bore is possible. Still though, I doubt you’ll find a replacement bolt for it for any reasonable price, and the cost of that ammo is substantial.

I appreciate the info, it will likely be kept as is. Thanks for your efforts everyone