Just curious if you are what are your loads? I'm using the Ogive reading off of factory bullets because they are shot through a semi auto. I've worked my way up to 42 gr of IMR 4064 safely. How high have you guys gone with the load?
Anyone else using IMR 4064 and Hornady 168gr BTHP?
- Thread starter patriot87
- Start date
ruger-ruger
CGN Regular
Using 44gr of 4064 with lapua brass Berger 168 grain hybrids and federal 210 primers.
Shooting in a Kimber tactical. Thing shoots basically one hole at 100 yards and is well under 1/2 moa to 800 yards.
That's as far as I have shot it as we are so wet here I can't move the bench back anymore.
I can tell you that this Kimber shoots as well as any of my customs.
Shooting in a Kimber tactical. Thing shoots basically one hole at 100 yards and is well under 1/2 moa to 800 yards.
That's as far as I have shot it as we are so wet here I can't move the bench back anymore.
I can tell you that this Kimber shoots as well as any of my customs.
- Location
- chilliwack BC.
I use this load in my K31.
very accurate. I only use 39grns, but its a very light load in comparison to the GP11 or the PRVI loads.
now that said, I can make tighter groups with Berger bullets
very accurate. I only use 39grns, but its a very light load in comparison to the GP11 or the PRVI loads.
now that said, I can make tighter groups with Berger bullets
