Anyone got a Rooster rail on a Swiss yet?

They are good. Here are some photos of the older one he did:

bluestarrail2.jpg


http://www.canadiangunnutz.com/forum/showthread.php?t=21675
 
There is a dovetail at the front of the receiver and a jam bolt at the back that presses against the sight base. You slip the front onto the dove tail and wind the bolt out to brace against the rear sight and there she is. This is how the rifle was designed to mount a scope and is very strong.
 
Rooster's new rail will extend out over the handguards a couple of inches which will make mounting scopes like Leupold LR/Ts really sweat :)
 
Ok folks... here it is, Rooster33's newest work of art. the extended Sig rail for the SwissArms target rifles and carbines. The holes in the top are treaded for ARMS #35 rings to attach directly should you fell the need to get really low. As you can see it is a inch or so longer than the his old rail which will make the mounting of long eye relief scopes possible out in front of the rear sight but low enough that the clip on cheek rest will not be needed. Or you can still mount high and use it but be able to use the long eye relief scopes like the Leupold LR/T without crowding it. I'll post more picks once I have mine on my rifle with the Leupold Mk4 3.5-10x40 LR/T.

roosterrail6.jpg

roosterrail1.jpg

roosterrail2.jpg

roosterrail3.jpg

roosterrail4.jpg

roosterrail5.jpg
 
You must log in or register to reply here.
Back
Top Bottom