I am thinking about mounting a holosun 507c which has the same footprint as the RMR and was wondering if anyone has done it and has example photos of it on the Canadian model. I see a lot of photos from companies in the states that seem to have a different suppressor height rear sight than the ones that we have up here.
Anyone had their CZ P10C slide milled for optics?
- Thread starter bleaches
- Start date
smelly pete
CGN frequent flyer
- Location
- Chilliwack, BC
Yes, Red Tower Armoury did a fantastic job on mine. I am unaware of different sight heights between countries? Here's a pic of mine, with the rear sight dovetail milled behind the RMR; went with a Glock dovetail, for better selection. Since the pic I've replaced the rear sight with one that is slightly higher than a ...regular?...sight (barely visible in the bottom of the RDS window) and I'm thinking about grinding down the front to match (bu-bye tritium
)
)
Last edited:
chronicdose
Member
- Location
- New Brunswick
Yes, I also had it cut by RTA. I may have been the first since their machine ####ed it up the first time (the designs they had were apparently off?) . They took it back, consullted with leupold (optic was a dp pro) and fixed it for free and also threw in free cerakote for the trouble. Highly recommended.
MikeyScuba
CGN Regular
- Location
- GTA, Ontario
Milled then cercoated.
