Anyone have a cz 858 / vz 58 with a UBR stock?

Jwirecom109

Jwirecom109

CGN Ultra frequent flyer
Rating - 100%
189   0   0
Location
Rural Alberta
Trying to decide what to put on my cz 858.

If anyone has a Cz 858 or vz 58 with the NEA adaptor with a Magpul UBR stock please post the picture for me (i swear i saw one before but i can't seem to find it online)

Thanks Nutters in advance.

Jwirecom109
 
Jwirecom109 said:
Trying to decide what to put on my cz 858.

If anyone has a Cz 858 or vz 58 with the NEA adaptor with a Magpul UBR stock please post the picture for me (i swear i saw one before but i can't seem to find it online)

Thanks Nutters in advance.

Jwirecom109
Click to expand...

Here ya go Jwirecom109, works great, solid well functioning stock, recoil goes straight back. Only consideration is the UBR stock of course does not angle down with the NEA Cantilever Scope Mount and Inline Stock Adapter. Orginal CZ858 stock angles down by design; straight back can make the original irons harder to lineup. It's hard to get low enough over the stock. I can get a sight picture if I turn the rifle on a significant angle. My son who has a thinner face can get a better line up with the original irons.

Not really a problem for me as I wanted pop up irons which would co-witness through a scope. So long as this is not a problem for you I say go for it, I am very pleased with this stock.

Here's a few pictures to help you decide.

P1040200.jpg

P1040198.jpg

P1040203.jpg

Resizeof1.jpg

ResizeofP1030651.jpg
 
Last edited:
the_klenzer said:
How's cheekweld with that scope? I'm running the same setup, but need to move to a stock with better cheekweld, was considering the UBR.
Click to expand...
When I had the NEA mount set-up like in that picture I found that having a CTR was nice cuz I could remove the check risser to use my iron's then place the check risser back on along with the mount to use the optic.
 
Jwirecom109 said:
you 100% sealed it for me i wanted to see if there was a gap between the adapator and the stock, but nope and it looks sweet, thanks so much
Click to expand...

Glad to help.


the_klenzer said:
How's cheekweld with that scope? I'm running the same setup, but need to move to a stock with better cheekweld, was considering the UBR.
Click to expand...

I find the cheek weld comfortable with this set up. Just need to adjust the UBR length for proper eye relief with this scope. This stock is very solid and does not budge, nice and tight.
 
You must log in or register to reply here.
Back
Top Bottom