Anyone try the Lee Inline Bullet Feeder Kit?

One of the best LEE has ever made. Forget about the finicky finger type bullet feeder, this inline bullet feeder is just perfect for any type of press. It comes with 2 sets of tubes, at least for 9mm. Feeding works like the case feeder tubes, with a gatling like action. However, it is not perfect. The mount that holds the gatling like base is a little loose. Maybe, it was the way they designed it. I am sure there will be hacks posted as more people starts using it.
 
Liked it so much I bought a second one. ;)

It seem the feeder tubes base is sort of supposed to fit loosely in the upright position. At worst, I'd 3D print a collar to tighten it up.
The weight of bullets helps to keep the magazine in place.
 
ambishooter said:
One of the best LEE has ever made. Forget about the finicky finger type bullet feeder, this inline bullet feeder is just perfect for any type of press. It comes with 2 sets of tubes, at least for 9mm. Feeding works like the case feeder tubes, with a gatling like action. However, it is not perfect. The mount that holds the gatling like base is a little loose. Maybe, it was the way they designed it. I am sure there will be hacks posted as more people starts using it.
Click to expand...

Thank you very much for your post, I have been following this thread thinking everyone was talking about the about the "finicky finger type bullet feeder" which I bought for my Loadmaster and to date have not been able to get it to work. QUESTION: Does anyone know if the Inline Bullet Feeder Kit will work with an older Loadmaster?

Thanks, Retreever
 
As long as there is space allowing the gatling mount, I am sure it will work. Otherwise, you will be limited to a single tube feeder. Thread size is standard for Lee and most brands, so it will fit.
 
You must log in or register to reply here.
Back
Top Bottom