Anyone using Inline Fabrication quick change ultra mount?

V

Vitulla

Member
EE Expired
Rating - 100%
4   0   0
Location
Laval, QC
Have a Dillon square deal b a RCBS Roch Chucker and getting a Dillon 650 and don't have enough space for all 3 on my bench. I was looking for a solution and stumbled on the ultra mount with quick plates so 1 mount does the trick. Anyone using this? Any advice?
Thanks
 
Yup, using the Jr. Ultramount model for my LNL AP and a single stage Lee press. I measured the height of the regular model and figured it would be too high. The Junior height worked out perfectly.
 
You must log in or register to reply here.
Back
Top Bottom