AP-67 rifle (VZ58 in 7.62x51)

[wojnar]

But for Czech Small Arms with exeption of Czech Republic we are the main market. They are not that big to refuse making for our market only

 

[TRaTSeRiF]

I'd buy one and at least one of their little brothers in 7.62x39.. Maybe 1 more in an SBR configuration.. And ok, one more in 5.56

 

[dimeN]

hard to stop at just one !

yep, i'd be in for one in 7.62 x 51... its just too friggin cool to pass by

has to have metal mags though...no plastic

 

[G.Mitchell]

I'd likely be in for one too.

Would be a fun hunting rifle

 

[.30/06 FTW]

But for Czech Small Arms with exeption of Czech Republic we are the main market. They are not that big to refuse making for our market only

Actually, I'd say the US is their main market. They'd still probably build it for us though.

 

[Dorian Gray]

I'd buy one (if 1k$ plus taqs or under). If it was with FAL mags it'd be even better.

 

[jeffcarr88]

I'd like one...as long as its around $1000

 

[Ar180shooter]

Guys, there's no way an AP-67 would be under $1000. There would be virtually no parts interchangeability between it and the VZ-58. This means that surplus parts cannot be used and new tooling would have to be set up in order to manufacture them. Both of these factors would increase the cost. My guess would be around $1200, possibly $200 or $300 more.

 

[jwillmoore]

Norinco can get it done for under 700 that I am almost sure of

We just need one of the bigger importers to take up this project.

 

[jeffcarr88]

Guys, there's no way an AP-67 would be under $1000. There would be virtually no parts interchangeability between it and the VZ-58. This means that surplus parts cannot be used and new tooling would have to be set up in order to manufacture them. Both of these factors would increase the cost. My guess would be around $1200, possibly $200 or $300 more.

At anything over $1,500...I'd rather buy an AR-10