AR-15's

paintedstag.jpg

paintedstag2.jpg

Here is the list of the latest build up.
- Stag lower with Stag lower parts kit
- KNS anti-walk pins
- Magpul MAID
- Magpul trigger guard
- Daniel Defense single point sling plate
- Vltor stock, rubber pad and buffer tube
- M4 upper, Stag bolt carrier and bolt
- PRI gasbuster charging handle
- Troy BUIS front and back
- Larue 12 inch rail
- Tango Down vert grip that has been cut down
- Magpul and KAC rail covers
- Larue low profile gas block which has been pinned
- 5.56mm 1:7 CMMG 16 inch midlength barrel
- A2 flash hider
- Millet DMS 1-4 gen 2 scope
- Larue 1.93 scope mount
- sling will be a padded Vickers BFG when I can get one.:D
- Magpul Pmags of course;)
- G2 Surefire flashlight in a no name ring mount
Well that's it for now. I just painted it with flat tan Krylon.
Thanks for looking.
Hoddie.

looks not bad ...but not the scope and mount damnit ...someone take the paint can away from him :D
 
A2 m-forgery
Almost ready!
(Minus a charging handle) *WTF: why won't you respond to my email or phone calls regarding this matter "unnamed cgn dealer"

The stock gives away the Manufacturer, and if you got that AR from the best CGN dealer of that particular manufacturer, we all know who that is...
 
Damn those SL8 sights look wicked on that thing!

Can you use them okay, or are they too low?

It took a bit of mod to run them on the back around the charging handle and I had to raise the front ring about 1cm from the base to get them to index but they work excellent now. I considered a barrel rear BUIS but I thought it'd sit too high under CQ/T. This was the next best thing as I had a spare set from a SL8-G36 conv.

I like the 416 look so there's probably some influence. If I did it again I'd probably go with a front rail that was lower and ran flush with the existing M4 upper.

I had a few inquiries on the parts list. As I recall it's;
an Colt M4 upper and a Law Enforcement Carbine lower
Brownells modular gas block
enhanced grip
KNS Push button takedown pin
Badger charging handle
Magpul enhanced trigger guard
Levang Linear Compensator
modified SL8 BUIS
Pushbutton 120lum disruption light w/throwlever mount
Leupold CQ/T w/ ARMS throwlever mount
VLTOR Clubfoot stock
 
Last edited:
Back
Top Bottom