Ar stock removal

[kevsrocco]

Hey all, could use some help.

I'm trying to remove the stock on my gun (regualar A2 fixed-style).

I took out the buffer and spring, now I'm trying to get the whole piece off. From what I saw on the net' I need to remove the top screw of the butt plate? (I'm guessing). I saw on another site them use a special tool for this. Do I need one or is it just on there really good?

Thanks for your help.

 

[Canuck223]

Yep, unthread the top stock screw, and the stock should slide off the buffer tube. They you'll need to remove the buffer tube. A strap wrench is good for no mar removal if it's tighter than hand tight.

 

[bigmatty]

beware of flying buffer retaining pin and spring.... :shock:

 

[skeetgunner]

beware of flying buffer retaining pin and spring.... :shock:

And the rear receiver take-down pin and detent. If it doesn't launch, it may still just fall out.

 

[Boomer686]

Take the time to use the right stock wrench tool. There is nothing worse than looking at a cool AR, only to see the lock ring has been butchered by some moron who used vice grips, a crescent wrench or a hammer and punch on it.
The $$$ you spend on the proper AR tools won't be wasted...... it's almost gauranteed that AR ownership will lead to multiple AR's, followed by lots of mods and then a build-up from scratch. :lol:

Regards,