I might take one. I'm still making my own billet lower that will have some nifty little features to it. One neat feature I'm currently working the design kinks out of is an ambi-bolt release/hold open that is located inside the front of the trigger guard and can be manipulated with the trigger finger.
AR180B scope mnts, which is best
- Thread starter jeepingpw
- Start date
No worries bryce your on my list for a lower also in works of custom ingraveing I want my reciver to say something about (killing zombies) (5.56) also my name something along that line..
It should be completed soon also should be able to put on your own grip like the ar-15 on my lower going to change the reciver so a ready mag clamp fits
It should be completed soon also should be able to put on your own grip like the ar-15 on my lower going to change the reciver so a ready mag clamp fits
I'm doing similar things. Some of the key features:
- AR15 grips
- More AR15-ish shaped mag well
- Rear drilled and tapped for ACE style stocks. Will have two positions to mount, high to put stock inline with barrel, and low to use stock irons (might not do this).
- nifty bolt release as mention
- AR15 safety
- Swiss Arms style take down pin (you know, the neat quick relase ones)
After the lower is done I hope to make a billet upper that is left side cocking lever with dust cover (cocking lever slot and ejection port), takes standard AR15 barrels (forends and rails fit also), flat top. Will have to do up a custom flat top gasblock too, might make it adjustable.
This is all on the drawing bored stuff right now. I hope to get started soon on the lower and have it sent to Dlask to have the magwell cut.
- AR15 grips
- More AR15-ish shaped mag well
- Rear drilled and tapped for ACE style stocks. Will have two positions to mount, high to put stock inline with barrel, and low to use stock irons (might not do this).
- nifty bolt release as mention
- AR15 safety
- Swiss Arms style take down pin (you know, the neat quick relase ones)
After the lower is done I hope to make a billet upper that is left side cocking lever with dust cover (cocking lever slot and ejection port), takes standard AR15 barrels (forends and rails fit also), flat top. Will have to do up a custom flat top gasblock too, might make it adjustable.
This is all on the drawing bored stuff right now. I hope to get started soon on the lower and have it sent to Dlask to have the magwell cut.
