Archangel AASKS kits on the way, preorder now!

hical.ca

hical.ca

CGN Ultra frequent flyer
Business Member
Rating - 99.6%
256   1   0
Location
Mission, BC
ARCHANGEL AASKS KITS ON THE WAY, PREORDER NOW! Last shipment we had sold out very quickly. Drop a line to preorder@hical.ca to guarantee a kit form this shipment, make the subject AASKS. As always, we will be getting these out to all our preorder customers right away as first priority.
 
Last edited:
How do these compare to the factory stock in terms of weight and minimum length of pull?

I am curious about these.
 
About the same weight, maybe a bit more. The min LOP is just a bit longer than the standard stock. I cant be more specific as i dont have one in stock to compare.

BabySeal said:
How do these compare to the factory stock in terms of weight and minimum length of pull?

I am curious about these.
Click to expand...
 
If you did a YouTube video comparing the AASKS to the factory stock it would get lots of hits.

There isn't much info on these out there.

I am also curious if material can be removed to allow use of Tech sights without exposing a hollow core.

Thanks!
 
I have one of these stocks. They are awesome.

For $500 all in (rifle+stock+optic rail) I have a gun that looks like it costs as much as an XCR.

Unbeatable value.
 
WHO CARES!! SHUT UP AND TAKE MY MONEY!!!! :)

lol I have a couple of these fully kitted out.
Absolutely epic.
a little longer, but worthy, quality unlike anything ive ever seen in an aftermarket stock before.
weight is slightly heavier. balance is good.

get a TAPCO front gas tube cover (square) and you end up with a second rail there, and it looks better than with the AK style round one that is functionally useless. cheap upgrade :)


A little modification to the slant rear cover enables you to remove the rear bolt cover on the sks without removing from stock.

kitty approved. bayonet mount bipod is a little on the cheap side but works well and looks great.
that is a laser on the front tapco gas tube cover and it does not interfere with the stuff on my wartek rail :) Nice and low pro.

mount your foregrip as far back as you can tho, cuz if you mount it forward on the flat part, itll make you reach forward too far to grip it..

where i have it now is about perfect for me.

1622294_10151911003901161_1354998596_o.jpg
 
Last edited:
picture showing the mod to the rear slant cover.
Just shave out at a bit of an angle a small amount.. so you can lift the rear receiver cover back and up to slide it out for cleaning.
absolute MUST if youre going to shoot corrosive, otherwise youre removing the whole thing out of the stock to clean it properly.

for non corrosive ammo, not an issue... no need.

1957912_10151911003471161_140738111_o.jpg
 
ADHDCanuck said:
picture showing the mod to the rear slant cover.
Just shave out at a bit of an angle a small amount.. so you can lift the rear receiver cover back and up to slide it out for cleaning.
absolute MUST if youre going to shoot corrosive, otherwise youre removing the whole thing out of the stock to clean it properly.

for non corrosive ammo, not an issue... no need.

1957912_10151911003471161_140738111_o.jpg
Click to expand...

OMG. WTF dude? Tell me that you did not just shoot Tigger moments before that pic was taken! ;)

Nice rifle btw.
 
You must log in or register to reply here.
Back
Top Bottom