B&t apc 223 pic thread-range report page 4
- Thread starter bfiles
- Start date
mr.fatstacks
CGN Regular
- Location
- "Best Place on Earth"
Negative on the Geissele super dynamic 3 gun for me... Just got the fcg in and tried to manually cycle it the action, no dice. It's binding up at the rear of it's travel.
Got those same mags but not sure if the floor plates are gued or not
finally i can join this party!
_DSC8425-Edit by AV12G, on Flickr
_DSC8429 by AV12G, on Flickr
_DSC8409-Edit by AV12G, on Flickr
the Surefire Warden fit perfectly, do i dare try and shoot it?
_DSC8420 by AV12G, on Flickr
url=https://flic.kr/p/SjMFdz]
[/url]_DSC8410-Edit by AV12G, on Flickr
now to choose an optic
_DSC8404 by AV12G, on Flickr
_DSC8425-Edit by AV12G, on Flickr_DSC8429 by AV12G, on Flickr_DSC8409-Edit by AV12G, on Flickrthe Surefire Warden fit perfectly, do i dare try and shoot it?
_DSC8420 by AV12G, on Flickrurl=https://flic.kr/p/SjMFdz]
now to choose an optic
_DSC8404 by AV12G, on Flickr
Last edited:
Mr Wolverine
CGN Regular
- Location
- Manitoba. Canada
Yes we did, but we will not be doing exchanges in the future. Short barreled restricted models will come with the break and the long barreled model will come with the flash hider. Any changes will be extra, we need to standardize to keep cost down. They are lock righted on and need to be heated to remove.
It would apear from the threads I have read we have many sasified customers, that is good. These are extremely well made rifles.
Very nice looking rifle! I am exited for you guy's. I can't wait for more range reports.
What profile the barrels are? Regular or skinny? Hard to tell from the pictures, I am just asking cause from what I am reading the rifle seems a bit heavy at around 9-9.25 lbs naked right? Also all those screws on the side of the receiver did anyone verify if they have locktite on them?
I bet that front handgard must feel awsome to hold , it looks comfortable! Its to bad about the stock height but that can be remedied and might be available later with a diffrent stock.
All and all it looks awsome and its great to have more NR guns out there.
Happy shooting folks.
What profile the barrels are? Regular or skinny? Hard to tell from the pictures, I am just asking cause from what I am reading the rifle seems a bit heavy at around 9-9.25 lbs naked right? Also all those screws on the side of the receiver did anyone verify if they have locktite on them?
I bet that front handgard must feel awsome to hold , it looks comfortable! Its to bad about the stock height but that can be remedied and might be available later with a diffrent stock.
All and all it looks awsome and its great to have more NR guns out there.
Happy shooting folks.
Got my APC223 out to the range tonight very briefly, and while I only had time to get 5x 5 shot groups on paper at 100 yds I am really pumped with the results! I fired 3 groups with 75gr Hornady Steel Match, one group of about 7/8", one group of about an inch and a half with 4 shots in 3/4" and one group that fell apart and came in at about 2". Also fired 2 groups with 55gr Hornady TAP. One group of about 3/4" and one group of 1.75" with 4 in 3/4". Considering that it was almost dark and my fingers were so cold I could hardly feel them I am very confident in saying these are most definitely sub MOA capable guns fed proper ammo with a good shooter. This will be my "go to" non restricted black rifle.
