The B&T telescopic stock only came with the Tailhook brace adaptor and I actually find Tailhook very nice if used just a regular stock piece. There is a conversion kit for B&T telescopic stock but it is another $150 USD which I just dont feel like spending at this time.
B T GHM9 Carbines Inbound
- Thread starter Nordic Marksman
- Start date
No, BT has the correct ghm9 with tele stock and buttplate butbits not a few hundred, its like 800$ fornthe complete unit
Where did you get yours with tailhook stock?
I have part BT-20517 which is around $500 + Tailhook which is another $100 something. The part needed to convert this to buttplate is BT-20546 and thats $155. All prices in USD and I got my parts from Scott at Tar Heel State Firearms and Tailhook form Brownells.
Wolverine gave me a quote of 800$ for the stock with buttplate and a possible long wait. Still haven't pulled the trigger on it.
You import it thru IRG or do they ship up here?
Thx!!!
stormwolf18
Regular
- Location
- Terrebonne
How about a muzzle device, any ideas?
Oil filter
Hahaha, jokes aside, it's 1/2 x 28. Pretty much any 9mm device should work. There are some 9mm AR ones that look pretty cool. I, personally, wouldn't bother with it. Not enough flash or recoil to warrant it in my case.
I took the GHM-9 to the range today. 150 rounds fired with no failures of any kind, using Federal aluminum case bulk ammo. Can easily put 5 rounds into a 1" group at 18 yards. The front hand guard and hand stop worked much better than I expected, and there were no issues with the reciprocating bolt and my left thumb even though they are quite close. The only uncomfortable issue for me was the safety lever on the right side that rubs against the first knuckle of my trigger finger - I either need a non ambidextrous safety lever or I need to file down the sharp edge of the lever on the right side. I am also going to try switching the pistol grip to the Magpul MOE-K version to see if the more upright angle will help.
speedjunkiesracing
CGN frequent flyer
- Location
- Kitchener Waterloo Area Ontario
Want a Glock mag version. Wow
I just got the Custom Smith Manufacturing folding stock and the vertical grip for my GHM9 and wanted to post it here for anyone considering getting this set.
The quality is awesome and pretty much on par with B&T for my taste.
I will get the B&T Tri Lug Adaptor part instead of the thread protector to have the exit point of the barrel little bit further out from the hand holding vertical grip.
Here is the pic with B&T telescopic stock and Gear Head Works tail hook for comparison as well
The quality is awesome and pretty much on par with B&T for my taste.
I will get the B&T Tri Lug Adaptor part instead of the thread protector to have the exit point of the barrel little bit further out from the hand holding vertical grip.
Here is the pic with B&T telescopic stock and Gear Head Works tail hook for comparison as well
I just got the Custom Smith Manufacturing folding stock and the vertical grip for my GHM9 and wanted to post it here for anyone considering getting this set.
The quality is awesome and pretty much on par with B&T for my taste.
I will get the B&T Tri Lug Adaptor part instead of the thread protector to have the exit point of the barrel little bit further out from the hand holding vertical grip.
Here is the pic with B&T telescopic stock and Gear Head Works tail hook for comparison as well
Folding stock and vert grip look badass!!!!
