Big block...94 octane, lotsa torque, lotsa fun, ya makes your choices and go with it.
Hmm , all this speak about 308's tumbling at the 900 mark , going subsonic etc is not so ? What does one do to make the 308 work extended distance and to reach 1000 with the pointy end ? I would like to use 308 and don't have any expectations other than a reasonable degree of success
I looked at this with my "Load from a Disk" software and found two damatic advanages for using heaver bullets for extreem ranges.
Using a 240gr bullet over a 110 gr bullet. With a 600 yd zero.
1- The 110gr starts out real fast but the heaver and higher BC 240 gr catches up on verocity at about 600 yds and there after goes faster than the 110 grain bullet. Also...
2- Due to the higher ballistic coefficient of .711 over the .322 for the 110gr, you should see about half the wind drift.
FYI, total fight time for both is within .04 second out to 1000yds.
30-378 Wby Mag
240gr @ 2702fps velocity/bullet hieght, 110gr @3792fps
Muzzle 2702/-1.50" 3792/-1.50"
100yd 2572/13.92" 3449/8.74"
200yd 2445/24.06" 3124/16.05"
300yd 2324/28.40" 2816/19.78"
400yd 2206/26.35" 2526/19.12"
500yd 2093/17.15" 2256/12.97"
600yd 1984/0" 2008/0"
700yd 1879/-26.08" 1779/-21.65"
800yd 1778/-61.83" 1574/-54.37"
900yd 1682/-108.68" 1392/-101.12"
1000yd 1591/167.96" 1239/-165.95"
/QUOTE]
Big block...94 octane, lotsa torque, lotsa fun, ya makes your choices and go with it.
Hmm , all this speak about 308's tumbling at the 900 mark , going subsonic etc is not so ? What does one do to make the 308 work extended distance and to reach 1000 with the pointy end ? I would like to use 308 and don't have any expectations other than a reasonable degree of success
T
Lots and lots of F TR shooters use the 308 and have no issue hitting the V bull at 1000yds.
Jerry
omb
I read a while back where a shooter was making comments about a previous 1K match that was windy and said the 6BR's and 223's did ok, but the 308's were blown off the paper. How is that ?
.
famous saying on this forum
" jus sayin "
It has to do F class 1K matches even if only once a year . The 308 is questionable @ 1000 , the 6.5/284 has a voracious appetite for stainless steel , so i thought the 270 may have better table manners . Would the 280 be a consideration ? As you can see, i'm choosing big bore over the sensible smaller choices.
I read a while back where a shooter was making comments about a previous 1K match that was windy and said the 6BR's and 223's did ok, but the 308's were blown off the paper. How is that ?
.
famous saying on this forum
" jus sayin "
If you like the 06 case and the 6.5 bore why not consider a 6.5-06 ?