So i'm looking to build a 10-22 up to a tacticool rig. I have a couple questions tho. I'm looking to replace the factory barrel with a bull barrel, Can I go to any length an still be legal? You guys have any recomendations on what to go with and what to stay away from?
Barrels, What to do?
- Thread starter cgypal
- Start date
There are no minimum length limits for rimfire rifle barrels, provided the barrel was manufactured at that length and not cut down to it. You still have to make the 26" minimum OAL, though. I think the standard stock with an 8" barrel just makes it over 26", but it wouldn't be by more than a fraction of an inch. You also have to cut the forearm down if you don't want it to stick out past the muzzle.
I would say that Dlask barrels are by far the most common ones around and they have a good reputation.
Mark
I would say that Dlask barrels are by far the most common ones around and they have a good reputation.
Mark
Wanstalls may have some Tactical Solutions bull barrels - some in wild colours.
Send them an email to find out what is in stock.
Dlask is good too and they have their own DAR22 receiver which accepts threaded barrels.
Check out Dlask's website.
Send them an email to find out what is in stock.
Dlask is good too and they have their own DAR22 receiver which accepts threaded barrels.
Check out Dlask's website.
