Battery install on airpoint micro

2.1 ASSEMBLY AND PREPARATION
OPERATION UNDER NORMAL CONDITIONS

2.1.1 Install Battery
a. Remove Battery cap (6) using the Tool (13B).
b. Insert Battery (7) with the positive end (+) toward Battery cap (6)
as can be seen in Fig 1.
c. Turn to the Rotary switch (8) to intensity setting 12 (max.) and tighten the
Battery cap (6) with the Tool (13B). When resistance is encountered,
proceed to tighten until the Battery cap (6) comes to a stop.
d. Verify that the red dot is present and that there is zero gap
between the Battery cap (6) and the ...
 
Yes, it does click in.

Just make sure none of the "arms" are bent in preventing it from being seated flat and you're good.
 
You must log in or register to reply here.
Back
Top Bottom