BC Steel Lips Repair ?

[foggy]

I have three Butler Creek Steel Lip mags that have split along the seam. Anyone know if there is a good way to repair them (epoxy ?) or are they just trash now ?
Thanks

 

[thebuckhunter]

They're trashed! Send them to me for disposal.. lol! Just put a SMALL amount of epoxy along the seam being carefull not to get any inside the mag. Should be good to go. If you're worried about epoxy in the mag, you could wrap the mag in hockey/electrical tape.

-Jason

-

 

[G.Mitchell]

I have one mag that split end to end...

I tried gluing it with a super glue, the fumes got everywhere and gummed the mag up. I took it all apart again cleaned and lubed the mag. Then wrapped it up tight with hockey tape in two areas. Since then not one failure from that mag...

 

[foggy]

Thanks for the suggestions, I'll try the epoxy method.

 

[saskboy]

For $30 just buy a few new ones, im sure you got your moneys worth out of them already.