BC Tactical Aimpoint / NEA MBUS Cowitness question.

_ox_

_ox_

CGN Regular
Rating - 100%
127   0   0
Location
South Okanagan
Will a BC Tactical hanguard, with an Aimpoint Micro T1 co-witness with an NEA railed stock adapter and NEA barrel clamp with Magul MBUS mounted on them.

I really like the look of the below rifle, but want to set up my Micro T1 to align with the MBUS.

DSCF1170.jpg


Do I
A. use an NEA hanguard rail with a T1 high mount
B. use a BC Tactical Hanguard with the standard T1 low mount
C. Find a scout mount and the T1 low mount.

If any one has any experience with any of the above combinations I'd love to hear from you.

Thanks
 
The rifle pictured above is mine.I have long since ditched the NEA parts.The railed stock adapter and railed barrel clamp was cool in theory for an MBUS.In real life though it dint work well.You had to hold the rifle almost infront of your face to line the sights up properly,was really awkward and dint lend itself well to the platform.Also due to looser tolerances of the VZ gas blacks some NEA barrel clamps dint even fit the rifle properly(mine dint fit right) In the end it looked cool but dint work well at all.As far as the co witness with a T1.Im sure with just a NEA hand guard set it will work fine.I had a TRS 25 on a NEa hand guard set i had and it did co witness well.The other parts though,dont waste your time or money.


p.s BC tact set(love it BTW) will NOT co witness.
 
Well classic case of to each their own.

I finished my rifle tonight and so far I love the setup. Both the MBUS and the Red Dot feel very comfortable for me to see thru and I achieved my goal that it all Co-Witnesses.

Here's the parts and Pieces I used.
NEA Railed Stock Adapter
NEA Railed Barrel Clamp (had to make a small shim to make it fit properly)
Magpul MBUS Gen 2 sights
BC Tactical Scout Mount.
ATAC Defence Micro Red Dot (Same dimensions as a T1)

When the sights are flipped up, they co-witness right in the middle of the Red Dot.

10inch.jpg
 
_ox_ said:
Well classic case of to each their own.

I finished my rifle tonight and so far I love the setup. Both the MBUS and the Red Dot feel very comfortable for me to see thru and I achieved my goal that it all Co-Witnesses.

Here's the parts and Pieces I used.
NEA Railed Stock Adapter
NEA Railed Barrel Clamp (had to make a small shim to make it fit properly)
Magpul MBUS Gen 2 sights
BC Tactical Scout Mount.
ATAC Defence Micro Red Dot (Same dimensions as a T1)

When the sights are flipped up, they co-witness right in the middle of the Red Dot.

10inch.jpg
Click to expand...

Nice looking rifle. Is the railed stock adapter on the same plane as the NEA upper hand-guard rail?
 
You must log in or register to reply here.
Back
Top Bottom