Benelli M4 Quick Bolt Release Tab.. Komando P4, Canuck Operator, TAC-12

Rx Arms Solutions

Rx Arms Solutions

Member
Rating - 100%
4   0   0
Hey Guys,

Just released this, it's made from 1095 hardened spring steel and parkerized. Very easy to install, requires no gun smithing, it just tucks in between the forearm and the forearm retaining band. Drastically improves the surface area for the bolt release button. Will also fit the turkish clones!

You can get one at www.rxarms.com for $34.99 including shipping

M4 Quick Bolt Release Tab.jpg


Let me know if you have any questions!
 

Attachments

  • M4 Quick Bolt Release Tab.jpg
    M4 Quick Bolt Release Tab.jpg
    76.5 KB · Views: 500
is there anything preventing it from being pulled out and away from the receiver if it got snagged on something....pulling it off??
 
Kingjenky said:
is there anything preventing it from being pulled out and away from the receiver if it got snagged on something....pulling it off??
Click to expand...

it is pretty tough steel, hardened to 65rc. it would probably snap if it was pulled hard enough or got snagged on something that caused it to substantially be pulled away from the gun. There is tension that keeps it resting on the bolt release button so it naturally wants to hug the gun, it doesn't pull away easy.
 
Last edited:
Cause i think RX either went down or the owner dont care anymore.

I have sent a few emails asking to buy one since last october, no reply yet.
 
Butcherbill said:
^^^S&J is coming out with something similar, it was just posted on their Instagram page the other day.
Click to expand...

I ordered a supposed S&J "oversized" release button when I got my M4, it would have been last year or the year before, and when it arrived it was just a clone of the regular sized one. I ended up keeping it because shipping it back to the store (which for the record was not S&J) would have cost most of the value of the thing in the first place. I did get the oversize charging handle I'd ordered, the tiny original one was tearing up the skin on my fingers when I was doing drills with it.

And I see the ones in the OP have sold out.
 
Big Bad said:
I ordered a supposed S&J "oversized" release button when I got my M4, it would have been last year or the year before, and when it arrived it was just a clone of the regular sized one. I ended up keeping it because shipping it back to the store (which for the record was not S&J) would have cost most of the value of the thing in the first place. I did get the oversize charging handle I'd ordered, the tiny original one was tearing up the skin on my fingers when I was doing drills with it.

And I see the ones in the OP have sold out.
Click to expand...

What a joke, i have seen these so called "oversized bolt releases" for the M4 as well and they are direct clones, its a total scam
 
You must log in or register to reply here.
Back
Top Bottom