Beretta 1301+ ZHUKOV-S® Stock - Yugo

[lmar]

Long story short, I have a spare Zhukov-S - Yugo Stock that use to sit on my Kodiak Defense WK180.
It came with an adapter to fit the stock to the firearm. I have the dimensions of the pocket needed to fit the stock to the rear of an adapter.
Yes, I know the adapter will need a pistol grip incorporated into it.

Been looking on the web to see if anyone else has done this - and I can't find anyone who has done this yet.

This is a design exercise - because I can. Thinking of 3D printing prototype out of PLA and then when fitment/geometry is correct - make it in anodized aluminum.

I am trying to figure out what the length of the gun is from the muzzle to the back of the receiver to determine if the folder will clear the charging handle as it folds to the right side of the receiver. Cardboard box is in mail so I have nothing to go on right now.

Some of my other projects over the years:

https://www.canadiangunnutz.com/for...-magazine-etm-release-standard-stock.2475179/
https://www.canadiangunnutz.com/forum/threads/sks-bolt-mod-angle-grinder-not-on-my-watch.2470494/
https://www.canadiangunnutz.com/forum/threads/ruger-pc9-carbine-adapter-single-mag.2237690/
https://www.canadiangunnutz.com/for...180-folding-stock-installation-guide.2130693/
https://www.canadiangunnutz.com/for...gazine-modifications-for-sr9-adapter.1974368/
https://www.canadiangunnutz.com/forum/threads/wk180c-charging-handle-retro-fit-kit-concept.1864160/
https://www.canadiangunnutz.com/forum/threads/wk180-control-system-optimisation-final-piece.1866505/
https://www.canadiangunnutz.com/forum/threads/project-thumper-overview.1416908/

Len

 

[1ABNDT]

I am working on a 1301Tac, using the Chisel Machining pistol grip adapter that has a picatinny interface, I am using a magpul UCS for the stock as it folds to either side.


The distance from the back of fhe receiver to the charging handle is 6 inches, I think this is the reason why most folders on 1301T are to the left side.

From the muzzle to the end of receiver about 26+/-

 

[Painkillers]

I am working on a 1301Tac, using the Chisel Machining pistol grip adapter that has a picatinny interface, I am using a magpul UCS for the stock as it folds to either side.


The distance from the back of fhe receiver to the charging handle is 6 inches, I think this is the reason why most folders on 1301T are to the left side.

From the muzzle to the end of receiver about 26+/-

NEEDS PICS (PICTS)!

 

[1ABNDT]

NEEDS PICS (PICTS)!

View attachment 1203136

Not quite done, when it is I will post up.

 

[lmar]

I am working on a 1301Tac, using the Chisel Machining pistol grip adapter that has a picatinny interface, I am using a magpul UCS for the stock as it folds to either side.


The distance from the back of fhe receiver to the charging handle is 6 inches, I think this is the reason why most folders on 1301T are to the left side.

From the muzzle to the end of receiver about 26+/-

Thanks for the information.