Beretta Onyx Pro Issue

[datatools]

Hello everyone, I purchased a Beretta Onyx Pro O/U 12 guage about a month ago. Beautiful gun, shots well in trap and I plan to use it for some general bird hunting. The other day while out shooting traps, I noticed that the button that gets pushed in when the barrel closes shut (in other words the button that causes the chamber level to switch shut) was bent upward. The gun seems to close and funtion fine and when pushing the button with my thumb nail to close the lever all seems well. But still I'm concerned it could cause damage down the road. Has any one else experienced this problem? Any comments are welcome? Thanks guys.

 

[happiness is a warm gun]

Its under warranty..so take it back for repair.

 

[datatools]

Its under warranty..so take it back for repair.

Yes, this is most likely what I will do. However, I'm hesitant because then I wont have it for the summer and I'm enjoying trap shooting on Sundays with the fellas. Any one else have comments?

 

[gttsc]

That button does normally point upward slightly...my 682 gold is in the back of the car, i can take picture of mine for a comparison if you like.

 

[datatools]

That button does normally point upward slightly...my 682 gold is in the back of the car, i can take picture of mine for a comparison if you like.

I compared my gun to some of the others yesterday, and it seems that all of them are a little ####-eyed. Shouldnt be a problem, I just wanted to make sure. Thanks.