Best trigger group replacement for WS-MCR?

T

ted_dent

CGN Ultra frequent flyer
Rating - 100%
162   0   0
Location
S. Ontario
I just picked up a WS-MCR and would like to upgrade the military feeling trigger. I have some options since I have a few triggers kicking around from my AR building days. i have read that some of the aftermarket ones do not fit and some do so I'm looking for input from anyone who has first hand experience as to what works and what doesn't.

Available to me are:
Timney drop in single stage skeletonized 3.5 lb
CMC drop-in Single Stage 3.5 lb
Geissele SSA-E two stage 3.5 lb

Thanks.
 
Last edited:
Most of the cartidge type dont fit without modification, there is a thread on the wk180 for triggers, they should be the same. Almost all of the open type do.
 
I have Geissele G2S in mine and it’s great. Lots of folks like trigger tech which works fine too... in fact I understand Kodiak is now selling Trigger Tech.
 
Ran a Geiselle ssa-e in my WK for a while when I had it. No issues at all. You can run cartridge triggers if you grind the bolt stop a little on the bottom below the pin. Doesn't need a huge amount taken off to clear a cartridge trigger.
On the semis I used to have I preferred running 2 stage triggers.
You can always try a paracord trigger job. Just did it to a cheap mil spec trigger in a straight pull build and it turned it into a pretty crisp 3.75lb trigger. I might give it another go to see if I can remove all the creep entirely.
 
You must log in or register to reply here.
Back
Top Bottom