blackhawk stock on 12.5 DA

[Mandown!]

ok so if you put the gen 2 BH stock on the 12.5DA grizzly it makes it restricted right? since on srfc the specs say "11.25” to 15” length-of-pull" that would make it 23.75'' fully closed, making it below the acceptable 26'' correct?

So what if you drilled a hole through the stock and pinned it at an acceptable length, would that be ok?

 

[na1lb0hm]

you are missing the receiver in there, which iirc is around 5-7 inches in length.
see this:

http://www.canadiangunnutz.com/forum/showthread.php?t=543171&highlight=blackhawk

 

[Brordo]

I have the gen2 on mine and it is still over the required length (even collapsed).

 

[Mandown!]

awesome, thanks guys. brordo how do you like it??

 

[Repro77]

ok so if you put the gen 2 BH stock on the 12.5DA grizzly it makes it restricted right? since on srfc the specs say "11.25” to 15” length-of-pull" that would make it 23.75'' fully closed, making it below the acceptable 26'' correct?

So what if you drilled a hole through the stock and pinned it at an acceptable length, would that be ok?

I have a Knoxx on my dlask 870 12.5, and it has lots of length left, no worries there..

Just measured mine, its just over 31 inches, fully collapsed.

 

[Brordo]

awesome, thanks guys. brordo how do you like it??

I like it alot...maybe too much

 

[Mandown!]

I've heard of people having trouble fitting them on theirs cause of screw size differences, whats that all about?

 

[jamiejaf]

The only trouble would be the socket head fastner. You'll need an extra long Allen key. Usually, it's provided. If you buy one second hand make sure you get the tool.