Hey guys...
Just wanted some opinions here...
I want to use my 15" grizzleyMAG for grouse this season. I was thinking of options for blocking my mags for 2 rounds. I have two mags for it, and I don't want to drill/rivet it. What I was thinking was this:
Taking the floor plate off, and take the spring out. Put two shells into it, and then use an old scrap piece of hardwood flooring, measured from the bottom of the follower to the floor plate of the mag. I would then trim it down enough to fit inside the spring. That way I could have one in the spout, and two in the mag.
Anyone else tried doing this? Any other ideas? Would this be sufficient for legal/regulation purposes?
Thanks
IS
Just wanted some opinions here...
I want to use my 15" grizzleyMAG for grouse this season. I was thinking of options for blocking my mags for 2 rounds. I have two mags for it, and I don't want to drill/rivet it. What I was thinking was this:
Taking the floor plate off, and take the spring out. Put two shells into it, and then use an old scrap piece of hardwood flooring, measured from the bottom of the follower to the floor plate of the mag. I would then trim it down enough to fit inside the spring. That way I could have one in the spout, and two in the mag.
Anyone else tried doing this? Any other ideas? Would this be sufficient for legal/regulation purposes?
Thanks
IS


















































