Blue Line AR 15 Lower

Miller854

Miller854

CGN Regular
Rating - 100%
59   0   0
Location
Canada
So I recently purchased a lower receiver for my AR 15 build project and I must say I think this lower is excellent. Buying the receiver was quite easy and the transfer went through in around two weeks. I would recommend this receiver to anyone who is planning an AR 15 build project. I used a Tapco stock kit and a CMMG parts kit and the install of the parts went smoothly. Looking at the finished product I must say if I ever build another AR I will most definitely buy from Blue Line again. Just thought I should spread the word.

workroom1004.jpg
 
I had wait just to see if I would see your belly or your feet in the picture. Didn't see neither, so good job.
 
Does your rear takedown pin sit flush to the frame? Or does it slightly catch the raised radius there...just asking...
 
Brordo said:
Does your rear takedown pin sit flush to the frame? Or does it slightly catch the raised radius there...just asking...
Click to expand...

It didn't sit flush at first but a short bit of work with my dremel sander got it to sit flush. Apart from that the entire lower build went smoothly.
 
Miller854 said:
It didn't sit flush at first but a short bit of work with my dremel sander got it to sit flush. Apart from that the entire lower build went smoothly.
Click to expand...

Thanks...that's the only issue I had with the one I built up for my son...as with you...some quick dremeling and it was good to go.
 
necro thread...

is there something wrong with these? seems to be a lot of reports of issues with the rear take down?

anyone order these recently? I want to buy a pair, but not if there are issues
 
You must log in or register to reply here.
Back
Top Bottom