I know a fellow, now deceased, that would check out a bore on a new rifle before fireing it, and if he really didn't like it would firelap it with one round.
He didn't particularly like doing this, but it saved him a lot of time.
He claimed that it was his experience that the rifle would become consistant far more quickly and usually have a bore that didn't foul as much.
Like it or not, some barrels, wether lapped or not will foul badly, even Shilen, Hart and Gaillard match grades to name a few. On the other hand, I've had a few cheaper bbls, such as Adams and Bennett that show almost no fouling at all and are just as accurate as the expensive barrels.
Lapping when done properly, and I'm not saying any of the above aren't, will usually enhance any bbl, there is also a camp that feels to smooth a barrel will also cause copper fouling.
As for a break in period of cleaning and scrubbing with JB or its clones, that's up to the individual. GitrDun has a very good system there and definitely deserves a try, especially with an out of the box, off the shelf Remchester or its ilk.
After all, it can't hurt anything and it gets all of the packageing protective lube off the rifle and out of the moveing parts.
The process of fireing any cartridge is going to cause wear on any barrel, after every shot. Some rifles will only shoot well with a little fouling, wether they be your favorite hunter or custom built bench rest and everything in between.
I love the rare rifle that will shoot to POA from a freshly cleaned barrel as well as from a slightly fouled barrel. Few and far between are these gems and if you have one, keep it, as finding another can be aggravateing as well as expensive. I personally think it's one of the reasons so many people buy and sell the same calibre and make of rifle so often, only to pick up another in the hopes of finding one that will perform well from almost any barrel condition. bearhunter
He didn't particularly like doing this, but it saved him a lot of time.
He claimed that it was his experience that the rifle would become consistant far more quickly and usually have a bore that didn't foul as much.
Like it or not, some barrels, wether lapped or not will foul badly, even Shilen, Hart and Gaillard match grades to name a few. On the other hand, I've had a few cheaper bbls, such as Adams and Bennett that show almost no fouling at all and are just as accurate as the expensive barrels.
Lapping when done properly, and I'm not saying any of the above aren't, will usually enhance any bbl, there is also a camp that feels to smooth a barrel will also cause copper fouling.
As for a break in period of cleaning and scrubbing with JB or its clones, that's up to the individual. GitrDun has a very good system there and definitely deserves a try, especially with an out of the box, off the shelf Remchester or its ilk.
After all, it can't hurt anything and it gets all of the packageing protective lube off the rifle and out of the moveing parts.
The process of fireing any cartridge is going to cause wear on any barrel, after every shot. Some rifles will only shoot well with a little fouling, wether they be your favorite hunter or custom built bench rest and everything in between.
I love the rare rifle that will shoot to POA from a freshly cleaned barrel as well as from a slightly fouled barrel. Few and far between are these gems and if you have one, keep it, as finding another can be aggravateing as well as expensive. I personally think it's one of the reasons so many people buy and sell the same calibre and make of rifle so often, only to pick up another in the hopes of finding one that will perform well from almost any barrel condition. bearhunter
Last edited:
