BRNO 602 trigger work

K

krocks

New member
Rating - 100%
84   0   0
Hey folks
does anyone know anyone who works on Brno triggers, or has successfully installed a Timney CZ 550 trigger on a 602. When I spoke to the Timney tech folks he said a 550 fit a 602 but I'm not so sure, there different safety systems.
Anyway, any help/advise for smoothing up a Brno trigger would be greatly appreciated
thanks
KK
 
Hi Ron
thanks for replying to my 602 trigger question I just want to smooth it out and get rid of the creep so it's a little crisper. As you likely know they come with two triggers a standard and a set trigger, I'd like to get the standard re installed and smoothed up. I don't like the idea of a set trigger on a 375 if I can get away without it
KK
 
Mine has the standard trigger has a trigger adjustment screw.

It is accessible by removing the bolt and is slightly recessed into the rear of the receiver, don't even have to take the rifle out of the stock for adjustment.
 
I had Ralf Martini work on my Brno ZKK601 a few years back, and he did a very nice job on the single stage trigger on that one.
 
You must log in or register to reply here.
Back
Top Bottom