'Brobee' on remington 750?

[DMcFaul]

Does anyone out there with a rem 750 or 7600 know if the receiver has the same ass-end as the Rem 870? Specifically can you install a 870 stock on it, and ultimately a Brobee stock adaptor to go the AR grip/stock route?

I did a bit of looking on the net and couldn't spot any 750's reconfigured like this.

 

[manbearpig]

i think they are the 20ga. dimensions. i seem to recall a thread with someone modifying a 12ga. sling plate adapter into a sortof 'adapter' to fit 12ga. stocks onto the 760/7600 receiver.

 

[Republic of Alberta]

Hey Ya I want to install a 870 folding stock on a 7600 and have the same question.

 

[ricradster]

Stock sizes

I've tried to swap stocks from my 750 to 870, and found the 870 stock is slightly too large to fit the 750.

 

[adrock]

As far as I know there was a thread on this, its the 20 gauge stocks that fit. Also that is what the guys at the local gunstore told me as well.

 

[pharaoh2]

I wasn't aware the 870 used a different stock for 12 and 20 bores. When you buy aftermarket synthetic stocks, their not marked as per gauge.

*Edit*

I did find this though:

Model 870™ Synthetic Stock & Fore-Ends
• Fits Remington Model 870 shotguns
• All weather fiberglass reinforced synthetic stock
material
• Rear swivel stud attached for easy addition of
sling with Universal Mag Cap installation
• Fits 12 & 16 gauge
• Order #: 18614
• Order #: 18611 (12-ga. Youth)
• Order #: 18613 (Mossy Oak® Camo)
• Order #: 19487 (Monte Carlo)

 

[SuperCub]

Cool ..........

 

[Can-down]

Here's an old thread showing an adapter I made using one of Badboy's sling loop's...
http://www.canadiangunnutz.com/forum/showthread.php?t=205617