Brownell's has mossberg. 500 magpul stocks in stock

On the SGA stock I see there are sling mounts on each side, is there any provision for a traditional sling mount along the centreline of the bottom of the stock?

The front of my 18.5" 590 only has the sling swivel mount on the end cap, and I'm not sure if this would work with a side mount at the rear.

Snapshot
 
Thanks, I found this which I think is what you meant.

Using that at the front and the rear side mount on the SGA would place the sling along the side of the shotgun rather than along the edge, is this a good configuration for shotguns?

I use something similar for AR-15 CQB and it works well for that.

Snapshot
 
Last edited:
Ebbnflo said:
Anyone know why it shows 500 and 590 in the write up but under the actual item it only list the 590?
Click to expand...

Not all 500s are the same; some have rails and heat shields that interfere with the fore-grip. IIRC most newer 500s without the tri-rail or heat shield will work, older 500s may not even if they don't have the heat shield/tri rail as some older 500's don't have removable fore-ends. Hope this helps.
 
Last edited:
590a1.jpg
 
You must log in or register to reply here.
Back
Top Bottom