Since there's some interest in mounting a rail for a red dot here's what I did. At the front of the top cover I mounted a 2" piece of picatinny rail by drilling 2 holes and using 2 short screws/nuts. Plenty of clearance for the nut underneath. Solid and works just fine. This is just one method. While at it, I removed the hand guard and mounting block and installed another piece of picatinny rail and used the same screws. Bought a folding grip off Ebay and installed it, a little loose but I think the factory one also has some play but once you grab it it's firm.
One of first ones into Canada and has the grey finish.
Note, I removed the barrel nut for some reason. It now has the non-restricted barrel/shroud as well as the restricted barrel. This one is from the next shipment and is black, not the current version.
One of first ones into Canada and has the grey finish.
Note, I removed the barrel nut for some reason. It now has the non-restricted barrel/shroud as well as the restricted barrel. This one is from the next shipment and is black, not the current version.
