Bula Defense XM21 EBR overview video

I couldn't see from your vid but I'm assuming that you had the front ring on the integral receiver ring and not on the chassis (despite them lining up and all)? I know that the cantilever scope mount goes on the front rail of the Sage and the older ones had the front ring on the chassis and the rear on a rail in the stripper clip dovetail but I always figured you were better off mounting directly to the receiver as far as maintaining zero if disassembling things goes. As always, beauty rifle!
 
rugbydave said:
I couldn't see from your vid but I'm assuming that you had the front ring on the integral receiver ring and not on the chassis (despite them lining up and all)? I know that the cantilever scope mount goes on the front rail of the Sage and the older ones had the front ring on the chassis and the rear on a rail in the stripper clip dovetail but I always figured you were better off mounting directly to the receiver as far as maintaining zero if disassembling things goes. As always, beauty rifle!
Click to expand...

Thanks for the kind words, guys.

Yes, the scope is mounted to the rails that are on the receiver. Nothing is mounted to the SAGE top rail. If you decide to run an XM21 receiver in a conventional stock, you can really move the scope down low since there's no top rail to worry about. If you went with a smaller objective lens, you can get really low.

Tony.
 
You must log in or register to reply here.
Back
Top Bottom