Burris fullfield 2-7

M

mike t

CGN Regular
Rating - 100%
92   0   0
I have had this scope 4 years now and installed it on a Tikka T3 30-06. Tried to sight in today and its shooting all over the place. Everything is lock tite and solid and I am shooting off a rest. The only thing zi can come up with is the scope must be broken inside. I took a bit of a tumble with it 2 years ago but it held zero without issue until now. The Tikka is new to me but I cant see it being the rifle as there are no marjs in the bore and the crown looks ti be fine as well. Any suggestions???
 
Contact Stoeger Canada (the Burris importer) and find out where the closest warranty center is.

Burris scopes are guaranteed forever and they will fix or replace "even if it was your fall" that caused the issue.
 
Kody said:
I would probably swap the scope and shoot the rifle again just to make sure you don't have a rifle problem.

Kody
Click to expand...

This. Double check with a known good scope and then, if it groups well in that test, the scope is the problem. If you still have problems, then you have a problem in the rifle.
 
BigUglyMan said:
This. Double check with a known good scope and then, if it groups well in that test, the scope is the problem. If you still have problems, then you have a problem in the rifle.
Click to expand...
I will swap scopes and see what the result is. Hopefully its not a issue with the T3. I cant see anything wrong with the rifle as the bore is clean and everything is tight.
 
You must log in or register to reply here.
Back
Top Bottom