Call For 3D Printers... Derya TM-22 Magazine chamber flag

Pushtone

New member
Rating - 100%
1   0   0
Location
BC
If there are any 3D printer folks out there looking for a profitable project I got one for ya.

The Derya TM-22 is a joyful little plinker with the nice feature of last-round hold open. However, the bolt stays open by function of the magazine, the instant the mag is ejected the bolt slams shut making flagging the chamber an awkward two-handed maneuver.

I'm picturing a 3D printed 'MAG-FLAG'. A shorter faux mag that extends below the magwell enough for a key ring and cloth "remove before firing" flag. That should satisfy any RO. Most importantly it would allow for one-handed flagging.

I could buy another 10rnd mag, remove the spring/follower and paint it orange. That would cost $30cnd so if there were a 3D-printed MAG-FLAG for $20 I'd probably buy that. These little guns are getting more popular so maybe there's a market forming.
 
If there are any 3D printer folks out there looking for a profitable project I got one for ya.

The Derya TM-22 is a joyful little plinker with the nice feature of last-round hold open. However, the bolt stays open by function of the magazine, the instant the mag is ejected the bolt slams shut making flagging the chamber an awkward two-handed maneuver.

I'm picturing a 3D printed 'MAG-FLAG'. A shorter faux mag that extends below the magwell enough for a key ring and cloth "remove before firing" flag. That should satisfy any RO. Most importantly it would allow for one-handed flagging.

I could buy another 10rnd mag, remove the spring/follower and paint it orange. That would cost $30cnd so if there were a 3D-printed MAG-FLAG for $20 I'd probably buy that. These little guns are getting more popular so maybe there's a market forming.

Post this on the FB group if you haven't already. There are a couple guys on there who 3D print stuff, including a speed loader for the TM22 mags that works extremely well for those with weaker fingers when loading multiple mags or the 25 rounders....
 
Back
Top Bottom