can it be called a precision rifle

dero338

dero338

CGN Regular
Rating - 100%
82   0   0
Location
moskito land, absurdistant
First, I want to say tanks to Guntech, jerry Mystic precision, Gary Bighorn sales and all others who took time to answer my questions
this build would have been a lot harder without their help

I started with a 700 SPS DM action got here used (watch out, DM action dont work with a BDL flor plate):HR:
Riflebasix erv-3 trigger
wanted to go canadian made with the barrel and delay was intersting with B7 (Robert Bessette) .308 1-10 26 inch
HS precision stock which I added a tacpro rest and made an adjustable butt
warnes 20 moa base
TPS high rings
sightron 8-32 lrmoa

and I used a PTG 308 win match reamer neck .341

and yes I used a chineese KING can lathe 14-40 ( its all by budget allows)



the babe

img0012icf.jpg
[/URL][/IMG]

target 5 shots at 150 yards

150vq.jpg
[/IMG]

5 shots at 400 yards

600v.JPG
[/IMG]

and 5 shots at 600 yards

400vb.jpg
[/IMG]

now, I still have to make a jug to thread the bolt handle and paint with armacoat

the load is with cci br2 primers, nosler brass, N150 and 185gr lapua scenar
 
Last edited:
Hot damn.

Very nice.

Looks like the high rings were required with the barrel contour?

What upgrade did you like the best or thought was most valuable / best results for cost?
 
the scope was just clear of the barrel with med rings but couldn't use the flip caps
got a set of high last week on EE I will switch the med on the swede 96 to replace the warnes sometimes

I cannot say what ungrade is best, because I started from a bare action
I didn't recut the thread because I dont feel confident enough yet and from lapping, only the receiver face was off a little. mabe when I rebarrel I will do if its not sold
the erv-3 trigger is great but I dont feel it is any better than the lv1
 
You must log in or register to reply here.
Back
Top Bottom