Can O' Worms Husky 1640 .30-06?

[Johnn Peterson]

hey John, could you post those pics again for me to see.

Pictures of my two Husqvarnas along with a couple of targets are on post #4 of this thread. Are those the pictures you wanted?

 

[Johnn Peterson]

1651 was .358 NM model of the 1640 line, just like yours.
Mine won't have the engraving but wears the same early "Crown Grade" stock as yours. They were offered in three basic "grades";

M/1651 - wich had the thiny stock like Why Not's 1600 Std (4100)

M/1651 "Special" wich had the "Crown Grade" stock, jeweled bolt and the "Timney-Tradewinds" trigger

and the M/1651 Lyx, wich had engraving on floorplate, jeweled bolt and the "Timney-Tradewinds" trigger

There were some special orders made too, but these are the most common (and official) models.

Thanks for the indepth info. Much appreciated. although I haven't used mine all that much, yet, so far I'm more than pleased.

By the way, are you looking for a set of dies? In anticipation of getting a 358NM, quite a while back at a few local gun shows I picked up a good supply of Norma factory ammo plus a set of RCBS dies. Part of the deal with the rifle was a set of dies so the set of RCBS are available. Thought I'd mention it incase you were looking. Other than that I'll sell or trade them off at one of the next shows.

 

[Pathfinder]

The second is a recently acquired one in 358 Norma Magnum.

for scott_r and Gatehouse

 

[Dime]

Hi-jack?