Canadian Norinco M305 ejector source?

When you hear it ping off that third wall, you know you're scr.wed. Been there, done that...:redface:

M
 
Last edited:
I keep Chinese extractors as spares for my GI bolts, but I've not had the opportunity to use one.
 
DarceMegarce said:
Lost my ejector during reassembly of the bolt...

Anybody know of a dealer in Canada that carries the Norinco ejectors?

If not, will the USGI M14 Ejector and Spring found here: http://www.treelinem14.com/Bolts-and-Bolt-Parts_c10.htm fit in the Norinco bolt?
Click to expand...

Yes, these fit and function well. I put one in my DA M14 a couple months ago after it spat the extractor and everything but the firing pin and bolt roller into some other dimension at the range. Got probably 150 rounds through it, no problems so far.
 
I'd buy buy more than just the extractor if ordering. A spare extractor plunger spring may be helpful if you bend yours during reassembly and is cheap insurance (ask me how I know...:). It might also be good to have a spare extractor plunger and extractor...just in case.
 
If you order from Treeline it's best to order enough parts to make the shipping charge worthwhile. I think the average shipping is around $25.00, I have ordered from them quite a few times and shipping is usually pretty quick. Be careful though, browsing thier web site is hazardous to your cedit card with so many parts available for shipping to Canada!
Rodney
 
rodauto said:
If you order from Treeline it's best to order enough parts to make the shipping charge worthwhile. I think the average shipping is around $25.00, I have ordered from them quite a few times and shipping is usually pretty quick. Be careful though, browsing thier web site is hazardous to your cedit card with so many parts available for shipping to Canada!
Rodney
Click to expand...

Correct just received my 3rd order. There will be more.
 
DarceMegarce said:
Lost my ejector during reassembly of the bolt...

Anybody know of a dealer in Canada that carries the Norinco ejectors?

If not, will the USGI M14 Ejector and Spring found here: http://www.treelinem14.com/Bolts-and-Bolt-Parts_c10.htm fit in the Norinco bolt?
Click to expand...

Yes they fit. Replaced my ejector and spring, as well as extractor and spring about a month ago from treeline. Cured my 305 stovepipe issues using the arms 18 mount right up.
 
You must log in or register to reply here.
Back
Top Bottom