Hi all!
Just picked up an FDE Canuck Operator Elite, very cool and happy with it so far while inspecting and checking operations etc/
It came with the adjustable stock installed, which is very cool, but it also included a full length fixed stock and slimmer pistol grip, which I think I prefer.
It came with (what I think are ) a bolt and washer for the stock to connect to the recoil/stock tube, a smaller bolt and washer to connect the pistol grip, a padded butt for this fixed stock, and a single self tapping/wood screw with a tapered head.
Now, I can fumble around and slowly teach myself how to remove the adjustable stock and install the fixed stock, but I'd rather full instructions on how to do it (what hex bolt size etc to remove the adjustable stock, how to screw on the butt pad etc)
I figured out how to extend and then rotate and remove the adjustable stock from the recoil/stock tube.. but that's about it. There are two hex bolts at the rear of the stock/receiver and theyre so flush I don't know what tool would get in there etc
The manual doesn't mention this second stock, does anyone have a link to a video or a document, or can they please tell me how to do this?
One key item is the soft butt pad - what two screws attach it? do I take the screws from the adjustable stock's butt and re-use them for this fixed stock?
is the single screw that was rolling around in the box one of 2 screws? am I missing a screw? etc.
Just want to make sure I do it right. It may be cheaper than the real thing but it's still expensive for me to mess around with too much..
Thanks for any help folks!
Just picked up an FDE Canuck Operator Elite, very cool and happy with it so far while inspecting and checking operations etc/
It came with the adjustable stock installed, which is very cool, but it also included a full length fixed stock and slimmer pistol grip, which I think I prefer.
It came with (what I think are ) a bolt and washer for the stock to connect to the recoil/stock tube, a smaller bolt and washer to connect the pistol grip, a padded butt for this fixed stock, and a single self tapping/wood screw with a tapered head.
Now, I can fumble around and slowly teach myself how to remove the adjustable stock and install the fixed stock, but I'd rather full instructions on how to do it (what hex bolt size etc to remove the adjustable stock, how to screw on the butt pad etc)
I figured out how to extend and then rotate and remove the adjustable stock from the recoil/stock tube.. but that's about it. There are two hex bolts at the rear of the stock/receiver and theyre so flush I don't know what tool would get in there etc
The manual doesn't mention this second stock, does anyone have a link to a video or a document, or can they please tell me how to do this?
One key item is the soft butt pad - what two screws attach it? do I take the screws from the adjustable stock's butt and re-use them for this fixed stock?
is the single screw that was rolling around in the box one of 2 screws? am I missing a screw? etc.
Just want to make sure I do it right. It may be cheaper than the real thing but it's still expensive for me to mess around with too much..
Thanks for any help folks!
