Carding Wheel?

[Kedive]

Is there any other place than Brownell's to buy a carding wheel?

I'm in the process of Re-bluing a shotgun using the solution from PJ's and I've finished doing all the small parts on the gun which turned out great and am ready to move to the barrel, receiver and pump slide. Was thinking that using Steel wool would make it much to time consuming and not very effective on the barrel rib.

As a secondary question any suggestions on what to use for a tank for the boiling water I've seen a few suggestions of eavestroughing.

 

[Mauser98]

A buddy of mine bought a carding wheel from Capilano Rock and Gem in North Vancouver. It's virtually the same as the Brownells product.

http://capilanorock.ca

When I started rust bluing I used a piece of aluminum eave trough in which to boil the barreled actions. I sealed the ends using high temp silicon reinforced with pop rivets. I boiled using the stove in my camper. The eave trough can be a bit tippy but I got the job done with no serious burns.

 

[trevj]

You could always resort to contacting Osborne Brush directly, and finding out who their Canadian Distributor is. May not be able to buy directly, but should be able to get sorted on who you CAN buy from or through.

Cheers
Trev