case neck trimming / trimmers

[ultimate_monkey]

so iv done a seearch and didnt find the info i was looking for, but did get lots of good reading.

but as far as case neck trimming goes, what brand of trimmer would you precission rifles shooters recomend? ill say im "new" to reloading for pure precission but not reloading in general. so in my eyes they all do the same thing, but like every thing im sure there is a leader of the pack, so what brand should i be placeing an order for?

thanks!

 

[Obtunded]

If you go to 6MMbr.com thay have several reviews of different systems. There are K&M and Sinclair systems that are very good, but above all, get one with a micrometer depth adjustment. You can never put back brass that has been taken off in error. Don't cheap out whatever you do.

 

[ultimate_monkey]

thanks, i dont plan to cheap out for this! no worries there, i figure im goin to be spending in the 175-225 range for what iv been seeing for any thing that seems decent with a micromiter adjust. im likeing the looks of the sinclair stuff, is but they have a fw modles, is one better then the other? or does one just come with more accessories? im pretty bad with this internet stuff, more of a hand on kinda guy, but the shop around here is pretty lacking in this dept. aka they have nothing to look at haha

 

[bedrock]

Ultimate, you have a guy just south of you in Gig Harbor. Russ Haydon Shooters Supply. He's on the web, good guy and a benchrest shooter. He'll point you in the right direction. For outside turning I use a Sinclair and for case trimming I like Wilson.